This rising of the grain can in a great measure be
prevented by passing a damp sponge over the work before commencing the
polishing, allowing it to dry, and papering it. After the rubbing or
smoothing-down process is finished, the work should be well dusted; the
polishing can then recommence. The above operation must be again
repeated with a rotary motion and gradually increased pressure as the
rubber gets dry, and finished by lighter rubbings the way of the grain;
this will remove any slight marks that may be occasioned by the circular
movements of the rubber.
Working too long on any one part is to be avoided, nor should the rubber
be allowed to stick even for an instant, or it will pull the coating of
polish off to the bare wood. The rubber should be covered with a clean
part of the rag as soon as a shiny appearance becomes apparent upon it,
or at each time of damping, and less oil should be used towards the end
of the operation, so as to gradually clear it all off from the surface.
Rubber marks can be removed by rubbing in a direction the reverse of the
marks with a half-dry rubber and increased pressure.
Pages:
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53