Another
cylinder is fixed on the same axis at a few inches distant; the
file on the edge of which is of a finer kind, and is used for
finishing off the points. The workman now takes up a parcel of
the wires between the finger and thumb of each hand, and presses
the ends obliquely on the mill, taking care with his fingers and
thumbs to make each wire slowly revolve upon its axis. Having
thus pointed all the pieces at one end, he reverses them, and
performs the same operation on the other. This process requires
considerable skill, but it is not unhealthy; whilst the similar
process in needlemaking is remarkably destructive of health. (c)
The pieces now pointed at both ends, are next placed in gauges,
and the pointed ends are cut off, by means of shears, to the
proper length of which the pins are to be made. The remaining
portions of the wire are now equal to about four pins in length,
and are again pointed at each end, and their lengths again cut
off. This process is repeated a third time, and the small portion
of wire left in the middle is thrown amongst the waste, to be
melted along with the dust arising from the sharpening.
Pages:
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254